Specify the VRF for Auto-sense ExtremeCloud SD-WAN ConfigurationNEW!

Before you begin

On switches that support only a single active VRF, ensure a user-defined VRF with a different name does not exist.

About this task

Perform this procedure to specify the VRF that Auto-sense uses for the SD-WAN configuration. On models that support a single active VRF, Auto-sense cannot create the dynamic SD-WAN VRF if an IP configuration already exists.

Note

Note

If the running switch configuration includes the dynamic SD-WAN VRF and you complete this procedure, the switch renames the dynamic VRF to your specified name, and converts the configuration to static.

Procedure

  1. Enter Global Configuration mode:

    enable

    configure terminal

  2. Specify the VRF name that Auto-sense uses for ExtremeCloud SD-WAN configuration:
    auto-sense sd-wan vrf WORD<1-16>